Hello All,
I am in need of suggestions regarding building parts that are coming out
.020" to big in Z on down facing surfaces and .020 to small on up facing
surfaces. The parts are built as segments and then bonded together to for a
complete ring prior to investment casting. Because of the nature of the
part I am not permitted to send the file out nor provide a more descriptive
description other then the segments are build so that they have the out side
diameter facing down toward Z=0. In the round they build fine but supports
prevent me from building this way.
Any suggestions would help.
Karl Denton
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:53:24 EEST