Dan,
We know that they are a quite a number of rapid tooling technologies out
there. Since we have a SLA, SLS and a ZCorp and that we possess a furnace,
we primarily work on those technologies. There are only approximately 6
licenses of KelTool worldwide (not sure of that number). We are not closed
at those technologies, but we have to start somewhere. There is the new MCP
technology that seems to be interesting too.
Sylvain Masounave.
>Why aren't you investigating 3D Keltool?
>
>
>In a message dated 10/21/99 8:25:22 AM Pacific Daylight Time,
>rp-ml@prototech.polymtl.ca writes:
>
> > We are presently working on a comparative study of rapid tooling
> > technologies such as RapidSteel, DirectAIM and copper polyamide.
___________________________________________________________
Sylvain Masounave
sylvainm@prototech.polymtl.ca
Centre Prototech
Case Postale 6079, Centre-Ville
Montreal (Quebec), CANADA, H3C 3A7
tel: (514) 340-3245
fax: (514) 340-3246
http://www.prototech.polymtl.ca/
___________________________________________________________
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:53:11 EEST