Hi all,
Since rp-ml has turned out to be the ultimate source of information on RE
too, I have a question for all you reverse people...
Have any of you used RevWorks for Solidworks with a digitizer arm? I just
downloaded the demo the other day and so far it seems to be pretty good,
but how about in the long run? Any comments?
Greetings,
Juha Suokas
__________________________________________________________
Juha Suokas, Researcher
Helsinki University of Tech FAX: +358 3 5250204
Lahti Centre TEL: +358 3 5250282
Saimaankatu 11 GSM: +358 400 970308
15140 Lahti EMAIL: suokas@ltk.hut.fi
Finland
__________________________________________________________
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:59 EEST