Joe,
You must also bear in mind that if a Quickcast model is left in a humid
environment, it is likely to warp. Where you had a straight thin-wall
section, it may end up like a banana !
So even for a demonstration model, it's best to keep it in a sealed bag
with silica gel when not being handled.
Regards
Trevor Howarth M.Eng
Rover Group Rapid Prototyping & Tooling
3rd floor, Advanced Technology Centre
University of Warwick
COVENTRY
UK
Tel. 01203 524788
Fax. 01203 524878
e-mail: trevor.howarth@rovergroup.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:45 EEST