Doug:
Try chemical etching or photoetching if material is under about 0.030"
thick. Look at Wire EDM or Abrasive Waterjet cutting if thicker (will
both work on thin materials as well). I am assuming you need no more
than a few hundred parts. Above that start looking at simple stamping
dies. It depends on the shape and detail of the parts required.
Forming will be a secondary operation.
Britt Ferrill
860 Foxwood Road
Madison, NC 27025
(336) 548-1244
bferrill@nr.infi.net
Impact - Doug Johnson wrote:
> I have a need for some prototypes of small copper contacts. Any
> ideas?Thanx,Doug JPrototyping Program Manager
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:40 EEST